CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] Match Control causing conflicts (

kvloover November 22, 2011 11:26

Match Control causing conflicts
1 Attachment(s)
I'm currently modeling the flow over louver fins with the same domain as an article to validate some things using Fluent and ansys workbench.

I'm however having trouble matching the top and bottem surface to be able to set up periodic boundary conditions in Fluent.

I've set up match controls on every individual inclined section (can't find a way to select multiple faces in one match control). But when I go to add the vertical segments it gives conflict errors

A picture of one conflict area is in attachment.

If any body can help, I'll greatly appreciate it.

kvloover November 26, 2011 04:41

I've found on this forum a comparable problem, with a reply that it is a bug in ansys 12.1. Does this still hold true for ansys 13, or am i missing something to make it work ?

rvl565 September 10, 2013 12:40


i am facing the same problem... have you found a solution to this yet?


Vidyanand Kesti September 20, 2013 10:23

I face the same problem i used mesh periodic interface in FLUENT

All times are GMT -4. The time now is 00:58.