CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Question about Shrink Wrap tutorial (http://www.cfd-online.com/Forums/ansys-meshing/94735-question-about-shrink-wrap-tutorial.html)

zhaohui November 23, 2011 22:48

Question about Shrink Wrap tutorial
 
Hello, I am wondering if anyone has tried the ICEM tutorial "Geometry simplification using Shrinkwrap". Well, I followed the tutorial step-by-step but when I check the mesh quality, unlike what the tutorial document says "there should be no errors in the mesh", there are lots of errors:confused:. In fact even simple inspection can see two holes at the two ends of the mesh.

I followed the instructions of the tutorial exactly. Just like before, every time I use ICEM, I began to doubt IQ, sometimes my IQ, sometimes the software developer's IQ.:o

If you can help me on this issue, thank you.


All times are GMT -4. The time now is 20:54.