CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] 2d parallel edges mesh problem (http://www.cfd-online.com/Forums/ansys-meshing/94811-2d-parallel-edges-mesh-problem.html)

skrzatchlewny November 26, 2011 13:18

2d parallel edges mesh problem
 
1 Attachment(s)
I am trying to mesh two surfaces separated by a thin wall. How to avoid elements generated through the wall? Is it a tolerance issue?

cheers!

PSYMN November 28, 2011 14:43

Two ways...

1) You could use patch dependent surface meshing...

2) It looks like you are using patch independent surface meshing, if so, you could setup "thin cuts" between the parts of the two curves. (look for it in the help for details)

Best regards,

Simon


All times are GMT -4. The time now is 22:57.