CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] mesh distortion (http://www.cfd-online.com/Forums/ansys-meshing/95563-mesh-distortion.html)

antonio December 22, 2011 07:43
mesh distortion
 
Dear all,
I am using ANSYS icem and trying to make a mesh of I would say a very simple geometry...however during this process the mesher is imposing very strange elemens (distorted) in one face of my model?Can please someone tell me how can i fix this?
Please see attached one picture of the anomaly.
Best regards.

http://imageshack.us/photo/my-images/197/drawingj.jpg/

http://imageshack.us/photo/my-images/862/drawing1o.jpg/

antonio December 22, 2011 07:54
http://imageshack.us/photo/my-images/593/drawing3b.jpg/

Sheyko December 22, 2011 08:46
wor the wedge geometry helps Y-block

antonio December 22, 2011 08:51
Sorry, Sheyko I did not understand your answer...Could you try to explain with more detail please?

Sheyko December 22, 2011 10:11
Are you using blocking? Based on your images I suppose you have wedge geometry?

antonio December 22, 2011 10:23
No. I am not using blocking
Basically in order to have this geometry I have created six planes. In each plane I have draw trapezoidal sections and then I have used the skin feature in order to have a body (in the end of doing this I have 1 part-1body). So, yes you can say itīs a wedge geometry.

Sheyko December 22, 2011 10:52
could I see icem-project or geometry?


All times are GMT -4. The time now is 03:42.