CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Fluent sliding mesh (http://www.cfd-online.com/Forums/ansys-meshing/95666-fluent-sliding-mesh.html)

srini8156 December 28, 2011 04:39

Fluent sliding mesh
 
I am a beginner in fluent. I created a simple sliding mesh problem wherein I rotated a tool in a fully filled tank. I created a bigger cylinder than my tool for the sliding mesh. But the cylinder does not seem to move. I gave moving mesh for the domain near the cylinder an angular velocity of 5 rad/s and the surrounding outer fluid a moving mesh but velocity=0rad/s. Then I created a wall for all the 18 faces of the tool which is immersed in the fluid. But I do not get a variable velocity gradient along the tool. Please help.

PSYMN December 30, 2011 21:38

I hope you also asked this question in the Fluent forum for more discussion...

It is not really a mesh setup issue.


All times are GMT -4. The time now is 08:39.