|
[Sponsors] |
[GAMBIT] Need help in meshing volume with Cooper mesh scheme in GAMBIT |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 3, 2012, 05:37 |
Need help in meshing volume with Cooper mesh scheme in GAMBIT
|
#1 |
New Member
Dinesh
Join Date: Nov 2009
Location: India
Posts: 24
Rep Power: 16 |
Dear Friends,
i m modelling a journal bearing with one groove in gambit. I have created a volume and want to mesh this volume by using "Hex/Wedge" and cooper scheme. My pressure inlet is bearing (outer surface) and output is shaft (inner surface) . Kindly help me in how to mesh this and choose inlet and outlet as source. Also help me in specifying pressure inlet and outlet while specifying boundary conditions in zone type.Kindly help.Thanks in advance. The volume created and error i have got is attached. Last edited by Dinesh_Dhande; January 6, 2013 at 08:00. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
Gambit Meshing volume problem | haamdy | FLUENT | 11 | August 10, 2007 08:39 |