CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] slice body not frozen (http://www.cfd-online.com/Forums/ansys-meshing/96536-slice-body-not-frozen.html)

alecon88 January 25, 2012 08:36

slice body not frozen
 
Hi! I should to slice my geometry for meshing single body, when I have done the geometry I created body not frozen because I needed to "add/cut material" tools and they was both possible only if the body was active and not frozen. Do you think that I can slice create a new part?
The problem is like if I have two concentric cylinder A and B but the second is shorter than first and is in the middle so I have to slice the first part of cylinder A, the middle of cylinder A which lenght coincide with the all lenght of cylinder B, the cylinder B and the end of cylinder A.
Thank you


All times are GMT -4. The time now is 07:01.