|
[Sponsors] |
January 29, 2012, 17:21 |
how i can check my pump mesh
|
#1 |
Senior Member
CFD
Join Date: Nov 2010
Location: United States
Posts: 243
Rep Power: 16 |
I design my pump on gambit and i mesh it on the same program how i can test my meshing?????????????
|
|
January 30, 2012, 01:21 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
what do you mean with test?
In Gambit you can examine your mesh http://my.fit.edu/itresources/manual....htm#gc_exmesh Else you can load your mesh into fluent, and then do a check mesh
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
mesh check failed / degenerated contact points | shohin | FLUENT | 16 | April 11, 2014 22:32 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |