|
[Sponsors] |
January 30, 2012, 00:10 |
Prism meshing
|
#1 |
New Member
Mahesh
Join Date: Jan 2012
Location: Pune
Posts: 5
Rep Power: 14 |
i completed prism meshing with messag of "stuck element". becuase of it i couldn't export mesh into cfx, it shows message that no 3D element found.
what does that mean? what is solution over it? if anyone have solution then please reply. you can mail me on mahesheducation@gmail.com |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] No quads after prism meshing | saisanthoshm88 | ANSYS Meshing & Geometry | 2 | February 6, 2011 05:28 |
[ICEM] Prism meshing | itsayapan | ANSYS Meshing & Geometry | 2 | May 28, 2010 04:52 |
prism meshing??? | Nitin Dewangan | CFX | 1 | August 1, 2008 18:35 |
Prism meshing in ICEM 11.0.1 | carno | FLUENT | 0 | April 1, 2008 07:24 |
Icemcfd: Preventing prism inflation collisions? | Joe | CFX | 1 | July 31, 2007 09:13 |