CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Faces Not Matched in ICEMCFD (http://www.cfd-online.com/Forums/ansys-meshing/96932-faces-not-matched-icemcfd.html)

kostas February 5, 2012 15:16

Faces Not Matched in ICEMCFD
 
Hi to everyone,
i am a new user of ANSYS ICEMCFD and right now i am dealing with a 3D geometry. Until the output process, i do not encounter any problem. However, when i am generating the .msh file,i see different number of faces between the opposite surfaces. After trying to reduce the nodes of my mesh, the faces were matched. However, i do not have the desired number of nodes. What can i do in order to have both the desired number of nodes and matched faces?
I used also association mesh to geometry. I also tried to extrude the mesh.again, the faces did not match.
THANKS


All times are GMT -4. The time now is 17:00.