CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Very simple problem encountered by a begineer (http://www.cfd-online.com/Forums/ansys-meshing/97042-very-simple-problem-encountered-begineer.html)

diamondx February 7, 2012 15:28

Very simple problem encountered by a begineer
 
1 Attachment(s)
hello everyone,
I'm new to icem. Here is my problem: when i draw 4 points, put edge between them to create a square, and to create a block. The block come out of the limit of the edges in the right (see picture) what can be the problem. Thanks you in advance

Cheers,
Ali

Far February 8, 2012 10:20

there must be some geometry entity placed at some other location, since block try to cover the maximum geometric extent.


All times are GMT -4. The time now is 18:35.