CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Automating Process in ICEM CFD (

Vitaly February 9, 2012 13:27

Automating Process in ICEM CFD

I have a geometry with a single inlet and approximately 200 outlets. I would like to add extensions to each outlet that is approximately 10*diameter.

I have completed a surface and volume mesh, and I want to just extrude the face mesh of each outlet.

Is there a way to automate this process?



All times are GMT -4. The time now is 10:05.