[ICEM] Problem with mesh importing in CFX

FrankW · February 15, 2012, 14:56

Hi,

i've build up a blocked mesh. This is my first one. After that i've generated an unstructured mesh. And at the end i exported it as cfx5. If i open it in CFX 13, i get the following message:

I have no idea what caused the error. Any hints are welcome. Additionally i've attached geometrie and blocking file.

thanks for help!

with best regards
Frank

rikio · February 16, 2012, 09:39

Refer to this thread, Error Converting ICEM Structured Mesh to CFX

There are weired blocks at the tip of the diamond like geometry, numbered 41 & 42 in the attached figure. Did you get this blk with the build-in tools?

FrankW · February 16, 2012, 10:13

..yes, all the blocks are created with build in methods. I've tested today a previous version of my mesh and it works. The blocks are shown in the attached picture. I make two operations after this version. I 've merged the vertices at the cone end. And i create a o-grid. I will test now witch operation is cause of that.

FrankW · February 18, 2012, 04:40

Problem solved! The reason was the merging of the 2 vertices at the cone end.

rikio · February 18, 2012, 07:42

Thanks for let me know. So merging vertex should be used with care.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	121	March 7, 2013 17:21
[ICEM] Problem making structural mesh on a surface	froztbear	ANSYS Meshing & Geometry	1	November 10, 2011 08:52
Problem in importing the Mesh	fred	CD-adapco	4	May 13, 2005 12:36
Problem importing ANSYS mesh, please help	Ankan Kumar	FLUENT	1	February 2, 2003 08:38
fluent mesh importing problem	Phil	FLUENT	0	February 19, 2002 03:44

February 18, 2012, 04:40		#4
FrankW New Member Frank Weise Join Date: Mar 2009 Location: Germany Posts: 20 Rep Power: 6	Problem solved! The reason was the merging of the 2 vertices at the cone end.

February 18, 2012, 07:42		#5
rikio Senior Member Rikio Join Date: Mar 2009 Location: SH, China Posts: 182 Blog Entries: 1 Rep Power: 6	Thanks for let me know. So merging vertex should be used with care.