|February 20, 2012, 13:53||
Question about Formatted Point Data
Join Date: Aug 2010
Posts: 42Rep Power: 6
Hello, all, thanks for reading this,
I was making a binary tree structure, and I managed to write a MATLAB writer that brings the tree into ICEM CFD via the formatted point data input, but I have a question.
Is it possible to build cylinders through this input as well? Basically, I have it so it continually writes curves for two points (but no surfaces because I don't need b-splining for a binary tree).
In other words, I can build the 2-D trees, but I also want to build 3-D cylinders on the 2 points as well. Is this possible?
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to put melting Point data of inert particle in DPM model||subhankar_bhandari||Main CFD Forum||0||July 26, 2010 07:28|
|How to get the data of second cell or point near the wall?||jelon||STAR-CCM+||0||April 24, 2010 02:04|
|extract point data||susan||CD-adapco||4||November 27, 2007 15:04|
|Monitoring data at a point within CFD domain.||James||CD-adapco||1||April 17, 2007 15:02|
|radial turbine data export question||ally||CFX||0||September 14, 2005 15:10|