CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Export Gambit mesh into something Ansys workbench meshing can read? (http://www.cfd-online.com/Forums/ansys-meshing/97627-export-gambit-mesh-into-something-ansys-workbench-meshing-can-read.html)

amad11 February 21, 2012 13:10

Export Gambit mesh into something Ansys workbench meshing can read?
 
So this is a little unusual, however I've made a mesh for a client using Gambit (and run on Fluent). They now want to run it themselves in CFX, so they want me to give them my mesh and they'll set up the problem for CFX in ansys workbench. Which file type can be used to do this? Thanks.

Far February 21, 2012 13:26

.msh or .cas are enough for cfx


All times are GMT -4. The time now is 01:20.