CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Meshing a Periodic channel with high curvature 2D airfoil (http://www.cfd-online.com/Forums/ansys-meshing/97649-meshing-periodic-channel-high-curvature-2d-airfoil.html)

ergometer February 22, 2012 02:00

Meshing a Periodic channel with high curvature 2D airfoil
 
1 Attachment(s)
I'm trying to mesh a 2D airfoil which represents a turbine blade by using this periodic channel that I saw in another thread. My mesh is shown in the attached picture.
I've made my own mesh that looks similar but when I turn it into an unstructured mesh I get a lot of errors saying periodic nodes do not have twins and I have a single edge problem around the perimeter of the mesh. Also attached is the picture of the problems I get when checking the mesh. Any help with why my mesh might have this error would help. Thanks.

ergometer February 22, 2012 02:01

1 Attachment(s)
Here is the message I get when checking the mesh

Far February 22, 2012 07:38

It is normal in 2D. Dont worry about it and read the mesh in Fluent.

ergometer February 22, 2012 09:16

1 Attachment(s)
The grid isn't being accepted into fluent. When I try to read the mesh I get the error "Build Grid: Aborted due to critical error"

Far February 22, 2012 10:13

either make the mesh periodic in ICEM or change boundary condition (periodic) to wall or interface and then export mesh


All times are GMT -4. The time now is 20:53.