CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Mixing structured with unstructed mesh (http://www.cfd-online.com/Forums/ansys-meshing/97663-mixing-structured-unstructed-mesh.html)

hadrien51 February 22, 2012 06:17

Mixing structured with unstructed mesh
 
1 Attachment(s)
Hello everybody

I trying to mesh a surface boat with the bottom structured and the rest unstructured.
Check this post:
http://www.cfd-online.com/Forums/ans...tml#post345599

I want to do the same mesh than the picture but with the boat, mixing structured with unstructured. I use in volume mesh the octree method and existing mesh part (for including the structured mesh)
I put the tin and the blk in dropbox.

http://dl.dropbox.com/u/3423073/casco.blk
http://dl.dropbox.com/u/3423073/casco.tin

I am not capable to mesh it ! I do it for the appendices (picture) but for the boat , this is not working, perhaps about the topology or faceted surfaces of the boat.

If you have a solution or advice.
Thank you in advance


All times are GMT -4. The time now is 23:25.