|
[Sponsors] |
March 3, 2012, 17:36 |
how to mesh a cylinder
|
#1 |
New Member
vahid
Join Date: Dec 2011
Posts: 7
Rep Power: 14 |
Hi everyone,
i want to mesh a simple 3-D cylinder not with gambit default grids but in the form of controllable number of nodes in every 3 directions and in the shape of concentric circles... can anybody help me? |
|
March 4, 2012, 02:44 |
|
#3 |
New Member
vahid
Join Date: Dec 2011
Posts: 7
Rep Power: 14 |
thanks far for your reply,
the cylinder is a finite and simple 3-D cylinder all i want to know is how can i create such a volume with meshes as mentioned above(controllable numbers of grids in every 3 direction while the number of grids in one direction is independent of the other direction). for this i decided to revolve a 2-D rectangular face with activating the "with mesh" option to create a cylinder with known number of grids and in the form of concentric circles but after revolving the face, just the cylinder was created but mesh didn't revolve with the face. |
|
March 4, 2012, 10:54 |
|
#5 |
New Member
vahid
Join Date: Dec 2011
Posts: 7
Rep Power: 14 |
Dear far i sent the picture and... to your email
|
|
March 4, 2012, 11:10 |
|
#6 |
New Member
vahid
Join Date: Dec 2011
Posts: 7
Rep Power: 14 |
I can't attach the pic to the post, can you give me your email address to send the picture?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
[ICEM] Injector Tube into a Big Cylinder - How to mesh? | Leepox | ANSYS Meshing & Geometry | 2 | November 25, 2011 11:45 |
rotating cylinder using sliding mesh | Tim Daly | FLUENT | 1 | November 10, 2008 00:02 |
ICEM block mesh with a ball in a cylinder tube | Li | CFX | 6 | August 11, 2008 06:44 |
mesh problem for cylinder | akr | FLUENT | 1 | January 30, 2007 00:43 |