volume creation problem
1 Attachment(s)
I import my geometry inside ICEM
it consist of 3 parts 1-Big Air Domain (Fluid) 2-small Air Domain(Fluid) 3-Turbine Blade (solid) (please see my Image first) The problem is I need to create one Volume contains the two parts (1 &2) that between them an interior surfaces I followed the following Forum discussion http://bit.ly/zFqtup But after meshing process I discovered that only the Big Air Domain is meshed (NO meshing occurred in small Air Domain) I think the error in the "Body create" procedures, I was choose two points inside Big Air Domain with Name "Air" then with the same name "Air" I choose another two points inside small Air Domain (please see image) Any suggestion Pls. Thanks |
All times are GMT -4. The time now is 15:59. |