free surface flow
Hello all!
I'm new in icem. May be my problem is trivial. I try to simulate the flow past the vessel in OpenFOAM. I need to get a good resolution of the grid near the interface between air and water. I created free surface plane and split the volume to two parts above free surface and low. . I produced unstructured mesh. But I've got a lot of bad quality elements in intersection of hull and free surface plane. Is it possible to edit them? What way is preferable?. http://img-fotki.yandex.ru/get/6001/...266_edcfd1e5_L http://img-fotki.yandex.ru/get/6001/...267_63d6af2c_L |
All times are GMT -4. The time now is 16:18. |