[GAMBIT] F1 Front Wing Meshing

andyjo22 · April 2, 2012, 20:31

Hi,

I am having a few issues meshing this F1 front wing in Gambit particularly at the transition point from the centre section to larger main element. I am getting two largely skewed (>0.97) tri's. Is this likely to be an issue with the geometry or meshing scheme.

I am using an unstructured box mesh immediately around the wing and the rest of the domain is a structured quad volume.

Any Suggestions?

Cheers

-mAx- · April 3, 2012, 01:00

can you post picture from your mesh and another one with a zoom of skewed elements

andyjo22 · April 3, 2012, 03:49

I can certainly post a picture when I get access in about 30 minutes. I can't locate the skewed cells however. Is there a way in Gambit to do this?

-mAx- · April 3, 2012, 03:54

yes.
Go to examine mesh (bottom right), and then in range you give the lower value (0.9 for instance).
If upper limit is 1, gambit will display all cells withi skewness between 0.9 and 1.
Or you can also enable "worst element" option, gambit will automatically zoom on worst element

April 3, 2012, 01:00		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	can you post picture from your mesh and another one with a zoom of skewed elements __________________ In memory of my friend Hervé: CFD engineer & freerider

April 3, 2012, 03:54		#4
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	yes. Go to examine mesh (bottom right), and then in range you give the lower value (0.9 for instance). If upper limit is 1, gambit will display all cells withi skewness between 0.9 and 1. Or you can also enable "worst element" option, gambit will automatically zoom on worst element __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Meshing 3D wing (hydrofoil) fails	klausb	OpenFOAM Meshing & Mesh Conversion	0	December 28, 2011 14:26
Wing Meshing	steve1	ANSYS Meshing & Geometry	1	July 5, 2011 09:14
Wing meshing help......	ACER	Main CFD Forum	0	January 31, 2011 18:20
Meshing for 3D wing with tubercle on the leading edge in GAMBIT	nvtrieu	FLUENT	0	August 14, 2010 10:13
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37

April 3, 2012, 03:49		#3
andyjo22 New Member Andy Join Date: Mar 2012 Posts: 6 Rep Power: 14	I can certainly post a picture when I get access in about 30 minutes. I can't locate the skewed cells however. Is there a way in Gambit to do this?