|
[Sponsors] |
January 6, 2017, 07:31 |
Face to surface problem
|
#1 |
New Member
Join Date: Jan 2017
Posts: 3
Rep Power: 9 |
Hello i got a question, i researched but couldnt figure it out.
I'm not able to Select the surface I want. selection surface.jpg Here I wanna select the whole middle surface, but only one piece of it could be selected. wanted surface selection.jpg Here what i want when i do surface selecting. Can u help me? Thanks in advance. Last edited by yucabiy; January 8, 2017 at 14:47. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |