CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Handling swept blocks (http://www.cfd-online.com/Forums/ansys-meshing/99788-handling-swept-blocks.html)

saisanthoshm88 April 11, 2012 12:34

Handling swept blocks
 
I converted a block into the swept block type in ICEM, when I try to extrude the free face of the resultant swept block I see an error that the extrusion actually fails.

Could some one please help me out.

Also my intention here is only to explore the feautures of ICEM CFD so I'd appreciate any description explaining the actual purpose of having the swept blocks.

PSYMN April 11, 2012 13:52

I also could not get it to work properly... It pops up and says that extrusion is not supported. I will ask about it...


All times are GMT -4. The time now is 04:26.