 |
 |
 |
|
|
|
[Sponsors] | ||||
Using Parameters in Transient Structural Calculations with Ansys WB |
 |
|
|
LinkBack | Thread Tools | Display Modes |
May 2, 2012, 10:55
|
Using Parameters in Transient Structural Calculations with Ansys WB
|
#1 |
|
New Member
Join Date: Mar 2012
Posts: 26
Rep Power: 3  |
Hi,
i would like to add a rotational velocity as a parameter in Ansys WB and as a ramped function over time in a transient structural calculation. The Problem is that i can set it as a ramped function if i use the tabular input for it, but if i want to use it as a parameter for Ansys WB the only choice i get is a constant value from start to the end of my transient calculation. Anyone knows how to set it as a time dependend parameter to ramp it up over time? Regards |
|
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| From Fluent 6.23 to ansys 12 structural | Rich1979 | FLUENT | 0 | April 18, 2011 09:40 |
| units of geometrical parameters lost | SoobY | ANSYS Meshing & Geometry | 2 | January 10, 2011 03:58 |
| Parameters and Fluent in Ansys 12 | Edu-R | ANSYS | 3 | October 24, 2010 12:51 |
| How to Export ICEM mesh to ANSYS Structural | SIVAPRAKAASH | CFX | 4 | December 27, 2007 23:54 |
| Ansys | Rui | CFX | 2 | March 2, 2007 11:16 |
Linear Mode
