Ansys 14 WB problem with updating design points

vitulaaak · August 9, 2012, 10:05

Hello,

i wanted to compare the results from v12 to v14. I took the .cfx file from my older simulation and started a wb project from this file. When I create parameters etc and i select the cases, that I want to run, the solver wont start. When I push update all design points it says that all design points are up to date despite there is no result file at all for any of the points. The obly thing, that I can do is to start solver and solve only the dp0.

Does anyone know, why this is going on and how to run the simulation?

V.

SaschaGH · September 5, 2012, 10:47

Hey vitulaaak,
I have no idea, what happens if you open your old project with the V14 ?

August 9, 2012, 10:05	Ansys 14 WB problem with updating design points	#1
vitulaaak Member Vit Houst Join Date: Apr 2012 Posts: 35 Rep Power: 14	Hello, i wanted to compare the results from v12 to v14. I took the .cfx file from my older simulation and started a wb project from this file. When I create parameters etc and i select the cases, that I want to run, the solver wont start. When I push update all design points it says that all design points are up to date despite there is no result file at all for any of the points. The obly thing, that I can do is to start solver and solve only the dp0. Does anyone know, why this is going on and how to run the simulation? V.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to Connect Points in Design Modeler to make airfoil profile (2D)	andrew_diablo	CFX	3	July 7, 2017 05:23
ANSYS 13 problem	zona	ANSYS	0	December 16, 2010 06:48
[Other] ANSYS CFX-Meshing problem of a wind turbine blade	Zoe	ANSYS Meshing & Geometry	1	July 14, 2010 02:02
ansys problem	ENGRTAHIR	Main CFD Forum	0	May 11, 2010 16:29
Ansys 12 Workbench problem when generating volume mesh	Sveink	ANSYS	5	January 6, 2010 03:17

September 5, 2012, 10:47		#2
SaschaGH New Member Sascha Join Date: May 2012 Location: Germany Posts: 14 Rep Power: 13	Hey vitulaaak, I have no idea, what happens if you open your old project with the V14 ?