|March 11, 2013, 06:06||
Mapping settings of Ansys Workbench
Join Date: Nov 2012
Posts: 17Rep Power: 4
I want to map a pressure distrubution data fronm a cfd code onto ansys mesh. There are a lot of options to use for the mapping but unfortunately the information is not very sufficient to make the decision.
It is possible to do the mapping by programme controlled option or it is possible to do it manually which gives the ability to choose kriging, distance based average etc. for the weighting.
I would be glad if someone with experience on this topic can give me some advice.
|Thread||Thread Starter||Forum||Replies||Last Post|
|ANSYS Workbench on "Uncertified" Linux Distros||hsr||CFX||239||September 26, 2015 08:21|
|Macro command combatibility ANSYS workbench||Tassos||CFX||6||January 13, 2014 05:19|
|Can't find Ansys workbench in CentOS||idil||ANSYS||1||October 11, 2012 08:44|
|Ansys workbench problem||Jonny6001||ANSYS||2||September 30, 2010 12:59|
|Import gmsh msh to Foam||adorean||Open Source Meshers: Gmsh, Netgen, CGNS, ...||24||April 27, 2005 08:19|