I am learning workbench by reading tutorial chapter 23 (link: https://www.sharcnet.ca/Software/Flu.../i1332347.html), after run the CFX solver, it showed
An error has occurred in cfx5solve:
| The ANSYS CFX solver could not be started, or exited with return |
| code 255: . No results file has been created.
I have checked reasons online but cannot understand what caused this problem, all I have done was following the tutorial. should anybody give me some suggestions on this? By the way, Is the definition file generated automatically?
|All times are GMT -4. The time now is 02:30.|