|March 21, 2013, 08:09||
Join Date: Mar 2013
Posts: 1Rep Power: 0
I am learning workbench by reading tutorial chapter 23 (link: https://www.sharcnet.ca/Software/Flu.../i1332347.html), after run the CFX solver, it showed
An error has occurred in cfx5solve:
| The ANSYS CFX solver could not be started, or exited with return |
| code 255: . No results file has been created.
I have checked reasons online but cannot understand what caused this problem, all I have done was following the tutorial. should anybody give me some suggestions on this? By the way, Is the definition file generated automatically?
|Thread||Thread Starter||Forum||Replies||Last Post|
|ERROR #002100056 CFX FSI problem||Hongdao||CFX||0||November 10, 2010 04:58|
|CFX Mesh Deformation problem||Silmaril||CFX||7||October 19, 2010 10:00|
|CFX Casting problem: Can it be done all in one?||jfasl||CFX||1||September 14, 2010 03:14|
|Fan Modelling Problem in CFX||Jenny||CFX||8||September 11, 2007 13:59|
|CFX 4.4 installation problem||Pandu Sattvika||CFX||1||December 1, 2001 05:07|