|May 15, 2013, 04:20||
Wall Roughness bigger than smallest cell size
Join Date: Aug 2011
Posts: 17Rep Power: 5
I'm dealing with the following issue: Simulating a rotating wheel with different roughness values on the tire surface. 1, 2, 4 and 8 mm. My smallest cell size is 1.25.
When simulating with 2, 4 and 8mm my results get unreal. I understand that when penetrating the smallest cell size, my boundary layer model change. My question is how does it change? What is the physical description for this? Y+ values are around 140, so I'm already in the log law layer.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fluent3DMeshToFoam||simvun||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||48||May 14, 2012 05:20|
|unstructure mesh size control near to wall using gambit||lalit kumar||FLUENT||4||July 6, 2010 15:13|
|critical error during installation of openfoam||Fabio88||OpenFOAM Installation||21||June 2, 2010 03:01|
|Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug||unoder||OpenFOAM Installation||11||January 30, 2008 21:30|
|Multicomponent fluid||Andrea||CFX||2||October 11, 2004 05:12|