 |
 |
 |
|
|
|
[Sponsors] | ||||
October 15, 2013, 10:00
|
incompatible mesh
|
#1 |
|
Member
shikha
Join Date: Aug 2013
Posts: 40
Rep Power: 12  |
Hello frndz..
I am working in a 3D wind rotor,modelled it in creo 2.0 and imported it to design modeller to draw the enclosure.I enclosed the rotor within a cylinder which again enclosed within a cuboid to give the boco's. I did meshing in ansys mesh itself...but when I exported to fluent...it is not taxing the file,showing error as: "Model information is incompatible with the incoming mesh" I think it has got some problem with named selection...but I am totally blank regarding what could be done. Plz I need help....thnx in advance. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] Missing face error from FLUENT even after repairing mesh + other questions | unknown159 | ANSYS Meshing & Geometry | 0 | July 5, 2013 20:18 |
| Inner geometry gets lost exporting mesh from ICEM CFD to CFX-Pre | powpow | CFX | 3 | December 20, 2012 09:14 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Linear Mode
