CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS (http://www.cfd-online.com/Forums/ansys/)
-   -   The CNVTOL command is ignored. (http://www.cfd-online.com/Forums/ansys/127213-cnvtol-command-ignored.html)

alialibas December 6, 2013 02:52

The CNVTOL command is ignored.
 
While I am trying to use batch mode for ANSYS, i receive an error shown below. But i can run this *.db by using interface. Do you have any idea for that?


*** ERROR *** CP = 1.482 TIME= 08:32:40
Degrees of freedom for the criteria label F do not currently exist.
The CNVTOL command is ignored.


Thanks


All times are GMT -4. The time now is 11:37.