Rotating blades of a fan Fluent?

guillaume1990 · March 19, 2014, 11:41

Hello !

First of all, is it possible to do the simulation of a fan? If yes, is there a tutorial please?

I would like to study the impact of air flow on the blades of a fan. So I modeled the fan as follows (see file). I put as a boundary condition: wall1 for the duct wall2 for the hub wall3 for blades with its support. I added to the input and the output a surface(not shown in the figures) for pressure_inlet and pressure_outlet. But in the study, how can I rotate the blades? Is it possible with Fluent?
Is there a tutorial for the simulation of a fan?

Any suggestion would be great !

guillaume1990 · March 21, 2014, 03:15

Can you just tell me if it's possible to simulate a fan just with design Modeler and Fluent? So that I don't lose time if it's not possible. Thanks !

March 19, 2014, 11:41	Rotating blades of a fan Fluent?	#1
guillaume1990 New Member Join Date: Feb 2014 Posts: 28 Rep Power: 12	Hello ! First of all, is it possible to do the simulation of a fan? If yes, is there a tutorial please? I would like to study the impact of air flow on the blades of a fan. So I modeled the fan as follows (see file). I put as a boundary condition: wall1 for the duct wall2 for the hub wall3 for blades with its support. I added to the input and the output a surface(not shown in the figures) for pressure_inlet and pressure_outlet. But in the study, how can I rotate the blades? Is it possible with Fluent? Is there a tutorial for the simulation of a fan? Any suggestion would be great !

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
looking for a smart interface matlab fluent	chary	FLUENT	24	June 18, 2021 09:07
Problem in using parallel process in fluent 14	Tleja	FLUENT	3	September 13, 2013 10:54
Fan settings in fluent	fluent_beginner	FLUENT	7	February 23, 2012 22:13
Moving Meshes or Rotating Refrence frame is suitable for Rotating Blades?	arash_7444	FLUENT	3	March 21, 2011 01:07
how can i make rotating cylinder in gambit& fluent	mohamed	FLUENT	1	April 1, 2008 03:28

March 21, 2014, 03:15		#2
guillaume1990 New Member Join Date: Feb 2014 Posts: 28 Rep Power: 12	Can you just tell me if it's possible to simulate a fan just with design Modeler and Fluent? So that I don't lose time if it's not possible. Thanks !