 |
 |
 |
|
|
|
[Sponsors] | ||||
May 26, 2014, 07:28
|
Sliding mesh or Dynamic mesh?
|
#1 |
|
New Member
Ashish Khadka
Join Date: Dec 2013
Location: United Kingdom
Posts: 5
Rep Power: 12  |
Hello,
I am trying to simulate a process where a wire passes through a heated tube furnace in Ansys Fluent. Since, the grid is symmetric as shown in images   I was wondering what type of meshing between sliding and dynamic would be more applicable. I am also unsure if the Solid Zone (wire) and Fluid Zone (furnace) geometry should be constructed separately if in case of sliding mesh. Could anyone please shed a light on me? Regards |
|
|
|
|
 |
| Tags |
| ansys, dynamic mesh, fluent, sliding mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
| Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
| Update of the variables after dynamic mesh motion. | gtg258f | OpenFOAM Programming & Development | 9 | January 18, 2014 10:08 |
| potentialFreeSurfaceFoam with Dynamic Mesh | GuilhermeMP | OpenFOAM Programming & Development | 1 | October 6, 2013 03:05 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Linear Mode
