 |
 |
 |
|
|
|
[Sponsors] | ||||
June 14, 2014, 17:33
|
[FLUENT] Attempting to OGrid but Failing
|
#1 |
|
New Member
Joshua Aviles
Join Date: Jun 2014
Posts: 5
Rep Power: 11  |
Hello,
I am trying to run a simulation of fluid flow past a cylinder in the middle of a wind tunnel scenario. At this point, I have completed blocking and am beginning to mesh and refine these meshes. One of the ways I am refining the blocks is to implement an ogrid. Based on a tutorial for meshing around a car model, I have selected the blocks inside and below the cylinder in order to implement an ogrid. But, these attempts have failed with the error message "ogrid failed." Essentially, what am I doing wrong? Thank you, JEA |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problem: Ogrid outside the block | Fred_Erik | ANSYS Meshing & Geometry | 3 | August 7, 2017 03:39 |
| [ICEM] Ogrid not successful | clocter | ANSYS Meshing & Geometry | 3 | November 10, 2013 05:40 |
| [ICEM] unwanted pre-mesh inflation around Ogrid | macfly | ANSYS Meshing & Geometry | 7 | September 25, 2012 09:41 |
| y+ Value & Aspect Ratio {Wind Tunnel Model} | FabioT | ANSYS Meshing & Geometry | 18 | October 5, 2010 15:00 |
| ogrid in ogrid | susan | CFX | 4 | December 20, 2007 05:58 |
Linear Mode
