|June 24, 2014, 10:03||
Using Single Grid with ICEM CFD
hariyo priambudi setyo pratomo
Join Date: Jun 2014
Posts: 1Rep Power: 0
does anyone know how to switch off the multigrid option in ICEM CFD?
I am trying to use my 2D test case by considering only one cell in the lateral direction. When I reduced the lateral cell into 1 cell, ICEM didn't allow me and it was written "9 nodes at least for multigrid level 3". Please your help.
Many thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[TurboGrid] turbogrid to icem cfd then icem cfd to fluent||tmeysam92||ANSYS Meshing & Geometry||0||May 7, 2014 06:25|
|Learn ANSYS ICEM CFD||easy_astronaut||ANSYS||2||December 15, 2013 16:34|
|[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent||ivanddd||ANSYS Meshing & Geometry||1||February 3, 2011 01:51|
|Can I specify boundary conditon in icem cfd||Harry||Main CFD Forum||4||September 23, 2010 13:28|
|ICEM CFD Modules||Boris||FLUENT||1||March 12, 2004 15:37|