Prism problem in ICEM CFD at inlet and outlet

benjaminhogan · October 24, 2014, 17:23

Hello,

Relatively new user looking at meshing a case for exterior aerodynamics of streamlined vehicles, in particular a wind tunnel validation study.

My problem is prism generation on the floor boundary not running to the inlet and outlets correctly. This causes the prisms to decrease to a small point which ultimately leads to terrible quality cells.

Please see the attached picture that I hope explains my issue. I am aware that the mesh appears quite coarse - I am just trying to eliminate the prism problem.

Any help or advice welcome.

Cheers!

Ben

mohammad · November 11, 2014, 05:55

If your geometry is not very complex, try using blocking...then you will have easy time with the prism layer

rolloblues · November 15, 2014, 11:17

Hi,

check the value of Max Prism Angle parameter under Global Prism Mesh Parameters. If you have 90 or less that may cause the error

October 24, 2014, 17:23	Prism problem in ICEM CFD at inlet and outlet	#1
benjaminhogan New Member Benjamin Hogan Join Date: Feb 2014 Location: Liverpool Posts: 8 Rep Power: 12	Hello, Relatively new user looking at meshing a case for exterior aerodynamics of streamlined vehicles, in particular a wind tunnel validation study. My problem is prism generation on the floor boundary not running to the inlet and outlets correctly. This causes the prisms to decrease to a small point which ultimately leads to terrible quality cells. Please see the attached picture that I hope explains my issue. I am aware that the mesh appears quite coarse - I am just trying to eliminate the prism problem. Any help or advice welcome. Cheers! Ben

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] ICEM CFD Problem with the boundary conditions while importing the mesh to fluent	sonic109	ANSYS Meshing & Geometry	2	September 3, 2014 00:56
1 Inlet 2 Outlet BC setup problem	vbchris	OpenFOAM	1	March 8, 2013 01:38
total pressure boundary problem ==> flow from outlet to inlet!!	mrshb4	OpenFOAM	0	November 20, 2010 12:41
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 15:45
VOF Outlet boundary condition in cfd - ace	JM	Main CFD Forum	0	December 15, 2006 08:07

November 11, 2014, 05:55		#2
mohammad Senior Member mohammad Join Date: Dec 2010 Location: UK Posts: 245 Rep Power: 16	If your geometry is not very complex, try using blocking...then you will have easy time with the prism layer

November 15, 2014, 11:17		#3
rolloblues Member davide basso Join Date: Jan 2012 Posts: 48 Rep Power: 14	Hi, check the value of Max Prism Angle parameter under Global Prism Mesh Parameters. If you have 90 or less that may cause the error