[rgunjegaonkar@gmail.com]

hello everyone here,

this is my 2nd thread for interface.
I m trying to do CFD Simulation of Vertical Axis Wind Turbine on Highway for torque.
I have tried simulation with creating interfaces in workbench mesh and solve using fluent.I used non matching mesh on interface wall,it gives me -ve torque with very low value.
Plse help me to do proper setting up for interface between stationary & rotating domain in fluent.I have set wall blade inside rotating wall moving with 0 rad/s still it shows note when i say check case "Review wall motion. Stationary wall motion relative to adjacent cell zone detected."

I can work with CFX also.
Plse help me to overcome this problem.

I am attaching few images for reference here.
Thank you.

[Abdiaziz]

Can u please comment how you solved that problem if u did it?? I have the same problem of interfacing between two domains in Fluent