|
[Sponsors] |
May 19, 2016, 05:35 |
Contact elements-Mechanical APDL
|
#1 |
New Member
philip
Join Date: May 2016
Posts: 4
Rep Power: 9 |
how to use contact elements in APDL? I need the interface behaviour of steel -concrete composite slab. Contac174 and Target 170 were used in the modelling of steel plate and concrete contact surfaces. But error messages are there like "normal of target element 14446 is not consistent with the normal of target element 14445 ". Around 6000 nodes have the same error.How will I rectify the error? Please help me.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mechanical APDL 16.2 Launch Fatal Error | Maciejz4 | ANSYS | 2 | May 28, 2016 13:13 |
Ansys SIG$ILL error | loth | ANSYS | 3 | December 24, 2015 06:31 |
Ansys mechanical APDL problem. | russogianluca90 | ANSYS | 0 | October 13, 2014 08:38 |
[Ansys v12] Testing contact elements, CONT172 and TARG169 | raffah | ANSYS | 0 | March 1, 2011 10:47 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 13, 2001 00:19 |