Help needed on boundary condition/Floating point error: Invalid number

caai9 · August 24, 2009, 12:37

I am working on binary fluidized bed reactor with heat transfer and chemical reaction.
I have 4 phases before reaction and 7 phases after reaction, i am using eulerian model in Fluent, now the problem is when i try to introduce another phase with air(primary) phase at the column inlet defined (velocity inlet) in Fluent i get error:
Floating point error: invalid number
i have even reduced the time step size to as low as 1e-6 and checked other things which could give this result but i have not been able to rectify the problem.Please help.thank you

PrandtlGlawert · August 25, 2009, 17:22

I think i´ve read somewhere those sort of errors usually happen when strong gradients are found in some parts of your mesh (large cells ).
What about smoothing (refining) your mesh in those areas?
Sorry if it´s just a simple answer, but wish it could help.

caai9 · August 26, 2009, 08:07

thank you Daniel, you r right about that but i my case this doesn't seems to be the problem.....anyways thank you

August 24, 2009, 12:37	Help needed on boundary condition/Floating point error: Invalid number	#1
caai9 New Member Ahad Imtiaz Join Date: Jul 2009 Posts: 7 Rep Power: 16	I am working on binary fluidized bed reactor with heat transfer and chemical reaction. I have 4 phases before reaction and 7 phases after reaction, i am using eulerian model in Fluent, now the problem is when i try to introduce another phase with air(primary) phase at the column inlet defined (velocity inlet) in Fluent i get error: Floating point error: invalid number i have even reduced the time step size to as low as 1e-6 and checked other things which could give this result but i have not been able to rectify the problem.Please help.thank you

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
inlet velocity boundary condition	murali	CFX	5	August 3, 2012 08:56
Solver error message!!!	IoSa	CFX	1	September 14, 2006 04:48
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 05:12
Boundary conditions?	Tom	Main CFD Forum	0	November 5, 2002 01:54
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

August 25, 2009, 17:22		#2
PrandtlGlawert New Member Daniel LLanes Join Date: Aug 2009 Posts: 11 Rep Power: 16	I think i´ve read somewhere those sort of errors usually happen when strong gradients are found in some parts of your mesh (large cells ). What about smoothing (refining) your mesh in those areas? Sorry if it´s just a simple answer, but wish it could help.

August 26, 2009, 08:07		#3
caai9 New Member Ahad Imtiaz Join Date: Jul 2009 Posts: 7 Rep Power: 16	thank you Daniel, you r right about that but i my case this doesn't seems to be the problem.....anyways thank you