|September 23, 2009, 04:48||
how to model a little baffle in the flow field
Join Date: Sep 2009
Posts: 1Rep Power: 0
hello, anyone see this help.
I want to simulate the effects of a thin little baffle on the whole 3d flowfield, but I can't mesh, because the baffle is a irregular form.
it connects several flow subdomain, I tried the mesh grow from it. But by now, I can't get a satisfying grids even with the tetra mesh.
So , can you give me some advice. thanks a lot.
or else, if you met or saw some similar cases before, would you please give me some clue. thanks.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with rhoSimpleFoam||matteo_gautero||OpenFOAM Running, Solving & CFD||0||February 28, 2008 07:51|
|Flow through electrical field||Ralf Schmidt||FLUENT||0||October 13, 2005 09:06|
|Injection of partical into flow field||M.Mahendran||FLUENT||2||November 24, 2002 01:54|
|Help: apply B.C. in my granular flow model ?||Derek Jing||FLUENT||0||May 8, 2002 22:32|
|about granular flow model||daninwin||FLUENT||0||January 19, 2001 04:47|