CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS (http://www.cfd-online.com/Forums/ansys/)
-   -   How to check the value of applied loads at keypoints ? (http://www.cfd-online.com/Forums/ansys/71006-how-check-value-applied-loads-keypoints.html)

pathfinder_jj December 11, 2009 21:44

How to check the value of applied loads at keypoints ?
 
Hi all,

I have several sets of result after solving my analysis, I could access different sets of result by picking set "n" result from: Utility Menu > General Postproc > Read Results> By Pick.

however, when I tried to check each applied loads for each set of the result from: Main Menu > List > Loads > Forces > On All Keypoints, it only shows the applied loads for the last set of result.

Is there anyway that I could check the values for other sets of the result ?


Thank you.

rikio January 5, 2010 10:26

I am not sure about the detailed method, but I think this could be done through APDL to do a batch run, to get the wanted results of several files.:)


All times are GMT -4. The time now is 08:13.