ansys modelling

suryadvirus · February 4, 2010, 19:26

hi
i need to design an airfoil of the wind mill. i have the natural coordinates in x and y.
can some one please help me how to insert these points in ansys so as to design the airfoil.

thank you

zxin · February 7, 2010, 15:27

I know that in the GM,designmodeler or blademodeler, you can insert points by coordinates (txt file or something else) of the points. you can find the information in help.There is a format you should follow. But I'm not sure if this works.
actually I 'm doing the same thing. If you find some other way, plz tell me

February 4, 2010, 19:26	ansys modelling	#1
suryadvirus New Member Join Date: Feb 2010 Posts: 3 Rep Power: 16	hi i need to design an airfoil of the wind mill. i have the natural coordinates in x and y. can some one please help me how to insert these points in ansys so as to design the airfoil. thank you

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Command Line Run for ANSYS	Liaquat	ANSYS	11	April 19, 2018 09:49
how to map resultd from cfx to ansys?	ritesh	CFX	2	June 1, 2011 07:52
How to model concrete slab in ANSYS and apply 2 million cyclic load.	jjc	ANSYS	3	April 12, 2011 04:47
Difference between ANSYS CFD & CFD	solamy	ANSYS	3	October 21, 2010 16:06
Exporting results from CFX to ANSYS ??	sohail ahmed	CFX	1	December 20, 2007 01:10

February 7, 2010, 15:27		#2
zxin New Member zhao xin Join Date: Feb 2010 Location: Goteborg Posts: 28 Rep Power: 16	I know that in the GM,designmodeler or blademodeler, you can insert points by coordinates (txt file or something else) of the points. you can find the information in help.There is a format you should follow. But I'm not sure if this works. actually I 'm doing the same thing. If you find some other way, plz tell me