|March 26, 2010, 20:53||
Parameters and Fluent in Ansys 12
Join Date: Sep 2009
Posts: 36Rep Power: 9
I´m doing a rear wing with the new Ansys 12, and I need to simulate some variations of the flap (angle of attack and it´s position from the main airfoil).
I put these values as parameters in the modeler, and now I would like to know if I can automate the simulations and get the Cl and Cd of each simulation. I want to do a table with all the combinations and their respective Cl and Cd to choose most optimized version.
The dimensions are defined as Input Parameters. ¿How can I define an output parameter?
Thanks in advance!
|March 21, 2014, 11:57||
Join Date: Oct 2013
Location: new jersey
Posts: 24Rep Power: 4
i would like to change the boundary condition (i.e the heat flux at a wall) by 50 units each time and run the case till it converges. right now i am using the modification tool in fluent but i would like to know how to write it as a parameter and use it to define the boundary condition at the wall. Any help on this would be appreciated. Many thanks for replying.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Reverse rate parameters with CHEMKIN imports||Kevin L||FLUENT||1||June 27, 2013 04:22|
|Fluent jobs through pbs||ibnkureshi||FLUENT||5||June 9, 2011 13:43|
|Fluent parameters for sailing yacht analysis||Daniel||FLUENT||0||April 24, 2007 06:47|
|Integration of a Custom C++ Model into FLUENT||Syed Haider||FLUENT||1||February 20, 2006 05:49|
|Some nondimensinal Parameters||American Larki||FLUENT||0||December 21, 2002 19:39|