 |
 |
 |
|
|
|
[Sponsors] | ||||
May 26, 2010, 09:18
|
Question about meshing 2D airfoil in icemcfd
|
#1 |
|
New Member
cxcxcx0505
Join Date: May 2010
Posts: 17
Rep Power: 15  |
I am doing the meshing for 2D airfoil naca0012 in icem cfd, the grid came out is not nice in the leading edge because of the lack of formatted point data at the frontal part.I want to build the data using C++,I know the equation,but I dunno how to make the steps for variable-X,the data found from internet is
something like 1.00000 0.00126 0 0.99280 0.00227 0 0.97989 0.00405 0 0.96352 0.00627 0 0.94455 0.00878 0 0.92350 0.01151 0 0.90075 0.01438 0 0.87658 0.01735 0 ...... I want to make more precise point,do anyone know how to solve this? Thanks. |
|
|
|
|
|
May 26, 2010, 15:07
|
Javafoil
|
#2 |
|
New Member
Giuseppe DiB
Join Date: May 2010
Posts: 7
Rep Power: 15 |
You can obtain a number of point for a lot of profile that you want downloading JavaFoil at http://darwin.wcupa.edu/webapps/javafoil/
good luck. |
|
|
|
|
|
|
May 26, 2010, 19:09
|
|
#3 |
|
New Member
cxcxcx0505
Join Date: May 2010
Posts: 17
Rep Power: 15 |
Thank you!
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Difficult ICEMCFD question: Extrusion | Walter | CFX | 11 | April 19, 2011 02:22 |
| Modeling Backflow for a 3D Airfoil (Wing of Finite Span) | Josh | CFX | 9 | August 18, 2009 11:31 |
| Airfoil "Near Leading Edge" Heat Transfer question | Glenn | CFX | 1 | July 7, 2007 06:47 |
| 2D simulation - ICEM meshing for CFX question | Ben Makhal | CFX | 5 | April 11, 2007 08:44 |
| a question about icemcfd ddn? | George | CFX | 3 | August 20, 2006 20:08 |
Linear Mode
