CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS (http://www.cfd-online.com/Forums/ansys/)
-   -   Please, need help (http://www.cfd-online.com/Forums/ansys/81575-please-need-help.html)

happy October 31, 2010 05:12

Please, need help
 
Hello every member...

Acually, nowdays I have to simulate my 3D system by ANSYS 12 (CFX). However its mishing was not ready to run and get results So I have to create its own mesh to be able to have results. my issue is that I cannot get starting correctly. So I wait your support during next a few hours although I have already practised many tutorials to be perfect..my sys is opened vertical squer channel with slip beside each corner on each single wall and there is heat resource at its centre bottom.Please, could anyone ,please, help me and I will give him/her extra information.
In general, I need some general guidenece like which best code to draw my own mesh and so on

Kind regards.:o

happy October 31, 2010 18:52


Is there any member who would like to help me? It is first time I use ANSYS 12....please give me any ideas
In reality, I have already attemped to use workbench to make the mesh.
Thanks so much in advance

happy November 1, 2010 04:02

Hi everyone

I wait your replying... are u busy so much....Or you ignore me....Or :confused:

michael_owen November 1, 2010 10:05

At least post a picture of the geometry.

happy November 2, 2010 02:04

My information
 
Hi micheal owen...

First of all, thanks for your replying and my system has has been done

regards


All times are GMT -4. The time now is 19:35.