CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS (http://www.cfd-online.com/Forums/ansys/)
-   -   creating point masses in ansys (http://www.cfd-online.com/Forums/ansys/81794-creating-point-masses-ansys.html)

ikmal November 7, 2010 05:38

creating point masses in ansys
 
i am very new to ansys.. i am trying to create a model of cantilever beam with two point masses.One mass in the middle and one mass at the end of the beam to simulate 2 degree of freedom system.However I had problem when I create the point masses.It asked me to select the geometry but I dont understand what it means and there is no selection..Could anybody help me to create point masses.


All times are GMT -4. The time now is 03:37.