|December 3, 2010, 06:08||
Fan Blade Simulation. 2D CFD with FLUENT? CFX?
I am trying to simulate a 2D fan blade section.
I have the geometry defined by points that I extracted from the CAD definition. I know the RPM too.
I would like to know how I could set it up since I am having trouble with the side boundaries, i.e. the ones that are not inlet or outlet.
I know FLUENT will be faster to set-up & run than CFX, but the latter would be more powerful in terms of pre-proccessing.
Could anyone help me, please?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Transport mesh from ICEM CFD, to Fluent, to Sysnoise||Wieland||FLUENT||2||April 15, 2012 06:28|
|Jet fan and Tunnel simulation||ahlo7||CFX||7||March 7, 2012 10:25|
|Propeller Fan Curve Simulation||Teng_YJ||FLUENT||2||February 16, 2009 19:37|
|which s/w for turbine simulation, Fluent/ CFX ?||Parag||FLUENT||0||March 8, 2007 02:28|
|which cfd software is best. fluent , cfx. or......||sijal||Main CFD Forum||13||October 6, 2004 09:54|