Not able to mesh a helix with boundary layer using gambit
 

I have a model of a helix with rectangular crossection. I have applied boundary layer to the four required faces using the parameters below. After that i applied the edge mesh and face mesh. When applying the face mesh face 4 and 12 of the geometry contains 4 skewed elements. If i continue further I am sure to end up with a very bad mesh.
The parameters are:

SOFTWARE: Gambit 2.3.6

Boundary Layer
First Row: 0.001
Growth Factor: 1.2
Rows: 2
Depth: 0.0022
Internal Continuity: ON
Wedge Corner Shape: ON
Transition Pattern: 1:1
Faces: face 1,2,4 and 12

EDGE MESHING
Interval Size: 0.5

FACE MESH
Tri-Pave
Interval Size: 0.5

The file is located at http://www.sendspace.com/file/rb4yyq

Kindly help me out with this project. I need it as soon as possible.