|April 28, 2011, 10:13||
Compressibility of a gas
Join Date: Jan 2011
Posts: 37Rep Power: 6
I am a little bit new to ANSYS workbench. And i am trying to figure out how to do a simulation fo compressibility of a gas.
Basically as see in the picture we have a steel tube inside which we have a metal which is dark in colour and argon gas.
The known properties of them are
alpha steel =14.5e-6/°C and E=175GPa
alpha metal=26e-6/°C and E=96GPa
Gas=Argon-Density=1.784kg/m^3,dynamic viscosity=23.9e-6kg/m-sec;Thermal conductivity=180e-4W/m-K
So my doubt here is what is the method to do this simulation and. do i have to use static structural analysis only?
Hope for a quick replyy
Thanks a lot in advance,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Constant velocity of the material||Sas||CFX||15||July 13, 2010 08:56|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|Two-Phase Buoyant Flow Issue||Miguel Baritto||CFX||4||August 31, 2006 12:02|
|Gas pressure question||Dan Moskal||Main CFD Forum||0||October 24, 2002 22:02|
|Nitrogen Gas Compressibility factors||Mark Wilson||Main CFD Forum||0||September 22, 1998 23:11|