CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS (http://www.cfd-online.com/Forums/ansys/)
-   -   1D-wall dissapearance anfter convertion (http://www.cfd-online.com/Forums/ansys/88254-1d-wall-dissapearance-anfter-convertion.html)

Hgyn May 12, 2011 05:37

1D-wall dissapearance anfter convertion
 
Hello,

i created a 2D duct in ICEM with a half high 1D wall in the middle and used tetra meshing. After conversion to FLUENT the wall in the middle dissapeared. Can anyone help to fix this?

Thank you.

With hex mesh it workes, when is split the blocking and associate the edge to the curve from the wall in the middle. How can I do that similar with tetra mesh?


All times are GMT -4. The time now is 13:26.